Shiva Knowledgebase
Knowledgebase Index and Quick Search
Signal Quality Error on a FastPath 5 (644783-DP96)
Product: FastPath 5 v1.0 |
Component: | |
3rd Party Product(s): |
Release Date: Pending |
The Signal Quality Error (SQE) is enabled on a 10 Base-T Ethermodule for a FastPath 5. On the Ethermodule board there is a dip switch that has 4 switches on it numbered from 1 to 4. In order to see these switches, the power on the unit must be turned off and the 10 Base-T module must be removed from the unit. You will then be able to view that by default, switch 2 is off. This means that the SQE (Heartbeat) is enabled. If you were to turn the switch on, you would disable it.
The functions of the other switches on the module are as follows:
Switch 1- Not used
Switch 2- Signal Quality Error (switch off means enabled, switch on means it is disabled)
Switch 3-Link Integrity (switch off means enabled, switch on means it is disabled)
Switch 4-PRC- Polarity Reverse Correction (switch off means enabled, switch on means it is disabled)
By default, all of the switches are off.
CAUTION
The contents of this document have not been technically reviewed by Shiva, please use this information at your own risk.
Disclaimer
This information is supplied without representation or warranty of any kind. Shiva Corporation assumes no responsibility and shall have no liability of any kind arising from supply or use of this material.
The information contained herein is proprietary to Shiva Corporation and/or its vendors, and its use or disclosure is subject to the restrictions stated in the standard Shiva Corporation license terms and conditions or the appropriate third-party sublicense agreement.
| Search | Site Map | Contact Us | Home |
